8° upward tilt · 182 × 196 mm · prints flat on the bed
drag to rotate · pinch / scroll to zoom
Footprint
182 × 196 mm
Height, front edge
37.5 mm
Height, rear edge
10.0 mm
Tilt
8°
Corner radius
14 mm
Speaker pocket
158 × 182 × 3 mm
Screw slot
7 mm wide, 130 mm long
Screw head recess
18 mm, from below
Top edge
4 mm rounded
Solid volume
723 cm³
Before you print
No measuring needed. The speaker sits in the pocket by itself. The slot runs 25 to 155 mm behind the front edge on the centre line, which covers where the 1/4" insert is expected, and the screw is optional.
If you want to bolt it down, put the speaker on, look up through the slot to see the insert, and pick a 1/4"-20 screw about 10 mm longer than the stand is thick at that spot: roughly 24 mm near the front of the slot, 14 mm at the middle, 4 mm at the back. Thread it in by hand and stop if it gets hard.
Print two of the same part, one for the desk side and one for the shelf side.
The speaker in the view is a simple block at the real size (155 × 180 × 240 mm). The driver position is approximate.
The four round recesses on the underside are for self-adhesive rubber feet, so the stand does not slide on the desk or shelf.